my project 90 rebuild

just thought i would start adding a few pics and see what people think as i will no doubt i will need help at sum point throughout the rebuild

so far piccys are as follows

Good going fella. Keep them coming

Galv chassis?
Looking good by the way

when you write that link, put img before and /img after, so it shows he pic on the thread, between brackets like this

needs to be the whole link though

Lookin good mate just built mine up its goin for mot Saturday

looking good.
Im planning on doing this in the new year.

nice 1! looks good!

What bush's have you got?

im using proflex blues a few of the mates have used them and they seem to be good but i will soon see

my next task at the weekend is threading the new loom thru chassi thats going to be fun and if i get chance sort the rear axle out get it stript down blasted

pics sorted

to thread the loom i used a length of twin and earth house main wiring as its flexible enough to bend but stiff enough to go straight down the chassis without bunching up, then when it gets to the other end, pull it through the hole (may take a bit of effort) and i worked front to back as it seemed easier. once its through the hole, make sure the loom is well protected and fix the loom to the piece of wire you origionally threaded, then just simply and CAREFULLY pull the loom through the chassis. job done.

don't put the loom through the Chassis, it just makes it more awkward to get at if you want to make any changes or repairs at a later date.

Run it through some conduit along the top of the chassis

Mine is cable tied to the chassis - this suits me as I intend to strip out the unused wires one day (when it's warm and dry).

i would leave the wires there, in case you want to use them for worklights or the such at a later date

just a quick update had a few hours on it today axle has been cleaned up and painted red also fitted the challenge rear relocation cones from adrenaline 4x4 and sat the tub on so not got far but its a start

keep up the good work

at the moment finding it hard to spend time on it with work being mental with crimbo but got a few days planned off and will soon get it rolling ready to put my current runabout onto the rolling chassi
does any 1 no if you have to have it vic or dvla checked once you have done the rebuild i have saved my receipts and doing pics as i go to prove but it wont have a chassi number on it as new chassi .. i was thinking of cutting the old chassi leg off the old chassi to prove the numbers etc wat do you think engine numbers and gearbox numbers match logbook or can you have them professionly stampt ?

I doubt very much it would need checking, unless it was classed as a right off or something. Not sure about the chassis number though