My Defender 110 300TDi Rebuild

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

MRTs300

Active Member
Posts
225
Location
Somerset.
Hello.
We'll this is my defender not long before I started pulling it apart. I got it from London area due to the low emission zone coming into affect and the owner had to sell.
I bought abit of a dog to be frank but was new to the defender and didn't really know what I was looking for. I think my sieve has less holes in it.!!! It had a set of alloys on it when I got it which I didn't like so sold them and got my self the modular steels.
Was really happy to finally have a defender but then I looked abit deeper.
We'll this was after I was pulling a trailer down the road and under braking the tow bar decided to pull out from the rear cross member and the trailer forced itself under the back of the truck. My friend who was behind me found this so funny. After I picked my rusty bits up off the floor we swapped trailer to another vehicle.
This is my first picture upload so long as this works I will add more and continue the thread.

image.jpg
 
Ok might have to switch to computer. Is it just me or does apple products look good from the outset but really suck when you want to do anything simple.
 
Ok i must be doing it very wrong. using the image upload bit and keeps coming out small? where am i going wrong?
 
Well i got the pictures to work. GO ME!


So This was the start of the strip down. i knew by now the chassis was to far gone.







Blue sheet to keep the rain off! Well i didnt want it to rust.
 
The point of no return!! started to get abit scared at this point but iknewit had to be done. How it ever past a MOTthe year before i never know. Not done by me i should add.











 
Back
Top