Metric twin circuit brake calliper

Need a twin circuit disco/rrc calliper asap! Must be for metric knuckle and must also be in serviceable condition as I just want to bolt it on and bleed it!

The one I was going to get is a bit worse for wear.....

That the one that has 2 copper lines on? Might be a daft question

yeah, thats the one! twin input and three bleed nipples

But I don't think you can get them metric dude!

You can the local place has one in metric but its a little past it in terms of rust :/ its like my old imperial one

Landrover seem to have just drilled the imperial ones out as I checked, the bolts are M12 and the callipers fit the bolts in the knuckle. That and they were still plumed into the system

Are these what your after if so will see if I've still got them.

Exactly the ones! Do they take an m12 bolt if so I'll have then off you

I think they do they if I remember right they where off a rrc will have a look for them tomorrow and let you know.

Cool thanks, should be a bi hex 13mm head bolt that fits

could you not run a 13mm drill through the imperial hole???
ive got 2 rrc twin circuits here, and there now off the car

I actually have a drivers imperial knuckle to go on but it's 4 hours in the rain I could do without so would rather pay for a second hand calliper in useable condition for now. Would have to buy a box spanner anyway so won't be much in it between a second hand calliper and new box spanner

Large grips or chisel

Buy a box spanner that you will need for evermore, change the knuckle, do the job properly, everyone's a winner and spend the rest of the money on an umbrella and some duck tape

I would but I don't have the time

Never had a chance to have a look today been changing a frame balljoint will have a look tomorrow.

Can't find them must of lost them whilst moving house sorry.

Ahh well, thanks anyway

Still after this?

Yes indeed

I have found them if you are still interested ?

Price ?