Hi everyone,
I have replaced my Series 2 engine, because over here in Australia they removed the Landy engines and put in a Holden 202 for a bit more power.
I am now back to a 2.25l petrol and one thing I have noticed is that when they did the conversion to the Holden, they removed all of the accelerator linkage across the firewall and to where the Carb is. With the holden, they just had a crude cable and that was it.
I have had an international effort to find all of the pieces and they are slowly arriving by post, however I cannot find anywhere that has the push/control rod that goes from the accelerator shaft and up to the cross shaft (Landy Part Number 509556 - #30 on the parts page).
If anyone has a spare few minutes, could someone please measure the length of the rod and I will have to make one up. I have found the ball joint socket ends, so I just need to know how long the rod is. A photo would be great too if possible.
Many thanks
Paul
I have replaced my Series 2 engine, because over here in Australia they removed the Landy engines and put in a Holden 202 for a bit more power.
I am now back to a 2.25l petrol and one thing I have noticed is that when they did the conversion to the Holden, they removed all of the accelerator linkage across the firewall and to where the Carb is. With the holden, they just had a crude cable and that was it.
I have had an international effort to find all of the pieces and they are slowly arriving by post, however I cannot find anywhere that has the push/control rod that goes from the accelerator shaft and up to the cross shaft (Landy Part Number 509556 - #30 on the parts page).
If anyone has a spare few minutes, could someone please measure the length of the rod and I will have to make one up. I have found the ball joint socket ends, so I just need to know how long the rod is. A photo would be great too if possible.
Many thanks
Paul
