how long is yours ???

johnny curt 1 · Apr 16, 2012

im gonna make me own drop plate for the back of me landy and i have worked it out to get 17+1/2" to the top of the ball i need to make a 12" drop plate wich looks right to me but can anyone confirm or measure the length of their plate so i have a comparrison please

cheers in advance lads

mad git · Apr 16, 2012

I just staggered outside, with me bad back, in the pizzin rain, in the dark, and measured mine for you

, it's twelve and a half inches, and not homemade.....

johnny curt 1 · Apr 16, 2012

mad git said:
I just staggered outside, with me bad back, in the pizzin rain, in the dark, and measured mine for you , it's twelve and a half inches, and not homemade.....

nice one fella so yours is au naturelle then

i keep lookin at this 18" length of 6" wide channel iron i got made from 1/2" thick rolled steel hard as **** it is but at the length i got i only have one chance with it

now get yer feet up and have a nice hot brew to warm yerself through old chap

mad git · Apr 17, 2012

no probs. It runs from the very top edge of the cross member, there are three sets of holes, to move the hitch up and down. And it's black..And who are you calling OLD...............................

blue beasty · Apr 17, 2012

mad git said:
no probs. It runs from the very top edge of the cross member, there are three sets of holes, to move the hitch up and down. And it's black..And who are you calling OLD...............................

Mines the same....at least is was till I chopped off the bottom pair of holes.

Figured I'd rather have the hitch a little high than dragging a plough

how long is yours ???

johnny curt 1

Well-Known Member

mad git

New Member

johnny curt 1

Well-Known Member

mad git

New Member

blue beasty

Leaks an prone to bits dropping off

Similar threads