Hole in bell housing.
- Thread starter Aidso
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 1,855
- Location
- Selby, North Yorkshire
If everything bolts up tight together, forget about it. I have run vehicles with lot bigger holes than a 2p and they've gone on for years.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,695
- Location
- Gloucestercotshirewolds
The bell housing isn't watertight anyway and there's no oil to escape (and if there is you want it to escape anyway) so I wouldn't worry unless your deep wading in which case you might want to blank it though water can get in to some extent where the starter bolts on and breathers and wading plugs would need sorting first anyway
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
2.5 diesel will have hole on drivers side top of flywheel housing for timing pin
