Hello everyone,
My name is Tom and im from south London, you could call it Greater London.
Im now the proud owner of a rather run down landrover discovery 1 from 1994.
I will be attepting to do it up, its runs fine so im likely to do interior, electronics and exterior cosmetics and work up to getting the engine at its peak. Ill be doing it on a budget, and all myself where i can.
Im new to alot of mechanics, I've tinkered a bit with breaks and the usual stuff. Im not new to DIY and I love a bit of woodwork and other craft. I did 3d print a part to the car (hand break gaiter retaining clip) which fit very well, but was not stong enough.
I look forward to contributing to the forum and benifiting from the cumulative years of experience that no doubt, the community holds.
My name is Tom and im from south London, you could call it Greater London.
Im now the proud owner of a rather run down landrover discovery 1 from 1994.
I will be attepting to do it up, its runs fine so im likely to do interior, electronics and exterior cosmetics and work up to getting the engine at its peak. Ill be doing it on a budget, and all myself where i can.
Im new to alot of mechanics, I've tinkered a bit with breaks and the usual stuff. Im not new to DIY and I love a bit of woodwork and other craft. I did 3d print a part to the car (hand break gaiter retaining clip) which fit very well, but was not stong enough.
I look forward to contributing to the forum and benifiting from the cumulative years of experience that no doubt, the community holds.
