Hard break peddle
- Thread starter peaky1979
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,264
- Location
- Near Poitiers SW France
What car are you talking about? If it's a P38, there is set procedure for bleeding the brakes detailed in RAVE the workshop manual.
Datatek
Well-Known Member
- Posts
- 44,264
- Location
- Near Poitiers SW France
In that case I cannot help, a problem for @Graculus maybe.
From the description it appears you've lost brake booster assistance - what was the reason you replaced the rear brake discs & pads? was it wear or an issue with the brakes?
If you were able to bleed them (not usually needed if you've just replaced the brake discs & pads) then the fluid circuits are probably OK. Can you take a photo of the vacuum pipe from the brake booster to the vacuum pump, specifically the part next to the engine cover - it should tee into two pipes that go to the vacuum pump.
If you were able to bleed them (not usually needed if you've just replaced the brake discs & pads) then the fluid circuits are probably OK. Can you take a photo of the vacuum pipe from the brake booster to the vacuum pump, specifically the part next to the engine cover - it should tee into two pipes that go to the vacuum pump.
