Glove box gap adjustment.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
PPP38vouge

PPP38vouge

Active Member
Posts
411
Location
deddington, oxfordshire
Hi all,
Got fed up looking at the half inch gap on my glove box, being a fussy git and like things to look right I thought I would have a look at adjusting the said gap. On the bottom hinges there are 2 Allen key grub screws which I loosened right off then took a look at the top two catches, if you get on your knees and look up at the catches in the glove box frame their are two small recesses just by the side of the catches which house a small Philips screw, what I did was to start tightening each screw half a turn at a time and low and behold the gap got smaller and smaller, I assume by tightening the screws, pulled the catches in to reduce the gap. I kept tightening until I was happy with the gap and then retightend the 2 grub screws. I now have a nice tight fit with a gap of around 2/3 mm, looks so much better and only took around 30 mins to do. Hope this helps any one else with OCD like I have. Lol
Paul.
 
PPP38vouge said:
Hi all,
Got fed up looking at the half inch gap on my glove box, being a fussy git and like things to look right I thought I would have a look at adjusting the said gap. On the bottom hinges there are 2 Allen key grub screws which I loosened right off then took a look at the top two catches, if you get on your knees and look up at the catches in the glove box frame their are two small recesses just by the side of the catches which house a small Philips screw, what I did was to start tightening each screw half a turn at a time and low and behold the gap got smaller and smaller, I assume by tightening the screws, pulled the catches in to reduce the gap. I kept tightening until I was happy with the gap and then retightend the 2 grub screws. I now have a nice tight fit with a gap of around 2/3 mm, looks so much better and only took around 30 mins to do. Hope this helps any one else with OCD like I have. Lol
Paul.
Click to expand...

OCD and a P38 !!!

This could be fun
:D
 
I really wish all I had to worry about with my P38 was the glove box................Oh hang on that's broke as well
 
Hi,
Think it may be adjustable from one side to the other, if the the lid is catching your pass side door may be worth looking at the hinges, may have worked them selves loose, a simple tighten up May cure that, there is a Philips screw and a 7 mm bolt holding in each hinge.
Paul.
 
Awesome. thought to have a look as my glovebox was gaping, now the perfect fit, sometimes it's the little things, thanks for the tip:)
 
You must log in or register to reply here.

Similar threads

H
Oh no! Not that old fog light question again.
Replies
14
Views
476
dag019
dag019
T
Auto Box Wont stay in Gear
Replies
11
Views
413
Graculus
Graculus
D
L322 Glove-box button no power
Replies
12
Views
3K
pwood999
pwood999
P
Is it always like this ?
Replies
7
Views
268
Kev12
Kev12
Blob
Disco 4 (LR4) Tail Light Theft - this might slow them down but only a little.
Replies
1
Views
758
biketeacherdave
biketeacherdave
Back
Top