front dump iron

tyre man dave · Mar 2, 2014

hi all.
wanted old series 3 dumb iron,s
wanting to fab some up using 3 / 4 mill plate
profile needed
any help
will be much appreciated

divie · Mar 2, 2014

One old offside one here that has not made it to the skip yet. I am in South Staffs.
Why 3/4 mm plate seems a bit over the top when they will fasten to 2 mm original chassis rail.

tyre man dave · Mar 2, 2014

wanting to a heavy duty warn winch
added strength

Dr_evil · Mar 2, 2014

brace it back to the front x member then, far easier

tyre man dave · Mar 3, 2014

need to repair dumb iron,s first
that,s why i was gunna make my own

divie · Mar 3, 2014

Got your message Dave, the one I have is good enough for a pattern. It has been patched. Nitemare of this parish replaced my dumb irons for me and I kept the offside one for the chassis number record.
Bit weighty to post on a cost for a pattern, try posting up for a relay?
It was going in the skip with the swarf off my machinery but I will hang on to it.
I have things to post later in the week I will get a cost then.

Dr_evil · Mar 3, 2014

if you have a spare make the pattern for him ?

just trace it out on cardboard and post the card up

tyre man dave · Mar 3, 2014

sounds good to me
its a plan

front dump iron

tyre man dave

Active Member

divie

Well-Known Member

tyre man dave

Active Member

Dr_evil

Banned

tyre man dave

Active Member

divie

Well-Known Member

Dr_evil

Banned

tyre man dave

Active Member

Similar threads