floor thickness

richardrosser · Aug 17, 2006

ready to put a new rear floor into the tub of my SIII but need some advice on the minimum thickness it needs to be for the MOT please - any one out there know, have looked on the net but cant find the information

slob · Aug 17, 2006

as the series landy has a chassis i don't thing the floor thickness will come into the mot. can't you measure a bit ot the old floor or even one of the footwell floors?

richardrosser · Aug 17, 2006

dooo - cheers Slob, why didn't i think of that

Zeberdee · Aug 21, 2006

I got a sheet of 1/2" ply covering the holes in mine! I also have some 3mm ali chequer plate in the garage.............one day I will get the jigsaw out.

slob · Aug 21, 2006

so i'm not the only fan of jigsaws here. i've got a lovely one of most landy models , its a 10,000 piece one a right bugger i can tell you

yella · Aug 21, 2006

i done a 3d jigsaw of a globe of the earth once, bloody hard that was i can tell you

Zeberdee · Aug 21, 2006

slob said:
so i'm not the only fan of jigsaws here. i've got a lovely one of most landy models , its a 10,000 piece one a right bugger i can tell you

Bet it isn't 10,000 pieces, if it is a proper landy one it will have some bits missing which would have had replacements carefully crafted from gaffer tape.

discomania · Aug 22, 2006

Nah, you leave the gap then fill it in with oil...

floor thickness

richardrosser

New Member

slob

Well-Known Member

richardrosser

New Member

Zeberdee

New Member

slob

Well-Known Member

yella

New Member

Zeberdee

New Member

discomania

Well-Known Member

Similar threads