Disco 3 (LR3) External temperature reading blank

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
L

LR-hobbs

Well-Known Member
Posts
233
Location
Coventry,west Midlands
HELPPPP

While I was working on the heated seat conversion I removed a black and green wire out of the middle plug connected to my HVAC unit and realised it was the wrong thing to do and plugged it all back in , ever since I did that my external temperature gauge reads -17° and my parking heater has decide to turn itself on.

I've plugged everything back in as it was and still no luck

Any suggestions welcome.
 

Attachments

  • IMG_20241015_132015_MP.jpg
    IMG_20241015_132015_MP.jpg
    165.5 KB · Views: 116
LR-hobbs said:
Would disconnecting the battery and leaving it for 10 minutes work?
Click to expand...
Well I was thinking along those lines, though I am no specialist in the D3, @gstuart is your man for this.
I also had a feeling that touching the big positive and negative wires together came into it somewhere but deffo don't do that until you have had a post from him!
 
Stanleysteamer said:
Reboot the whole car!!!




(puts hat and coat on and leaves!)
Click to expand...
That is called a hard reset, disconnect battery leads from battery, join lead ends together for a few seconds, this discharges all the capacitors etc in everything on the vehicle, reconnect leads and thats is it.
Sometimes have to do this when you cannot get fault codes to clear, but you have just fixed the bloody thing!
 
You must log in or register to reply here.

Similar threads

D
300tdi temperature gauge
Replies
8
Views
3K
drfoster
D
P
Voltage reading in ground cable(s)
Replies
2
Views
410
patrickr90
P
R
Horn tried to start a fire
Replies
7
Views
961
Anaconda
A
AJ-90TDi
New 90 TDi Owner - let the journey begin
Replies
15
Views
2K
AJ-90TDi
AJ-90TDi
P
L322 Battery Drain
3 4 5
Replies
86
Views
11K
marjon
marjon
Back
Top