Engine

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Yannis

Yannis

Active Member
Posts
205
Location
Milan
Right, got the engine out and have done the stuff that needed doing! now getting it back in we have spent quite a bit of time wiggleing it about but the main shaft will not go back into the clutch! has any one got any tips or tricks that will help us to get everything back in again?

cheers

yannis
 
yes everyting is centered! can get the unsplined bit of the shaft in, but cant seem to get engine perfectley allined for splines to interlock.
 
there isnt any "trick" to this - just make sure the vehicle is level and that the engine is the same - having a load leveller of your engine hoist will help much more than you'd think as there is only a few degrees between fit and no fit
 
put into a gear, then turn front pulley with a spanner and splines shud enter into clutch friction plate, make sure that bellhousing and engine are spot on in line as they are/can be bastids if out of align
 
Stop, go and have a cup of tea, relax, then go back and try again, taking in the advise above.
You have got a jack under the gearbox so that you can adjust the angle of this haven't you?
 
ask dave mentioned, i'd also recommend havin a jack under the g/box for adjustin the angle, really helped me when i was workin on me own pullin out engines!
 
i know it dint help here but if yer take the g/box out put a 1/2af socket between the injun and x/member. this keeps the injun at the reet height and angle of the dangle fer ease of refitting g/box
 
You must log in or register to reply here.

Similar threads

D
Td5 defender vibration
Replies
11
Views
692
bankz5152
bankz5152
S
throttle linkage problem
Replies
5
Views
614
sprie
S
pabloako
Air Filter / Battery Tray installation
Replies
3
Views
599
pabloako
pabloako
S
Engine installation and running
Replies
4
Views
661
dag019
dag019
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
8
Views
3K
miktdish
miktdish
Back
Top