Engine mount part numbers

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

Webley1991

Well-Known Member
Posts
2,579
Location
London
The engine mounting rubbers on my 1972 SIII SWB with 2 1/4 Diesel engine could do with replacing. I notice there are quite a few different ones available. What are the part numbers I would need for this vehicle?

Am I right that there are 6 in total? (4 for engine and 2 for the gearbox). I don't feel like going out to check now.

Thanks for any info.
 
How easy are these things to change?

I have been told that I will need an engine crane. The bolts look difficult to get to as well.
 
Don't need crane for gearbox. Just support underneath. Might be worth removed exhaust and handbrake for access.
Don't know about engine mounts.
 
Don't need a crane for the engine either.......right one can be changed by slackening gearbox mounts and jacking engine.....left one needs unbolting from the block to slip the rubber out
 
I have noticed a braket on the front of the engine block which is held in place by two bolts. We have an overhead crane at work. Is this bracket intended as a lifitng point for the engine? If it is, I will support tne engine on this from the crane to do the front two mounts.

For the rear two, where is a good place to jack the gearbox?
 
You must log in or register to reply here.

Similar threads

R
Freelander 2 (LR2) Auto Gearbox problem
Replies
7
Views
407
Alteredtech
Alteredtech
Aflyingduckling
Series 3 Fuel Pipe Issue (part 564902)
Replies
1
Views
718
steve2286w
steve2286w
S
LAND ROVER DISCOVERY 3.0L 306DT I WANT TO FIT A GEN 1 ENGINE INTO A GEN 2
Replies
1
Views
689
lynall
L
F
Freelander 1 TD4 Manual 1st Gear Switch
Replies
3
Views
588
freelounger
F
P7XES
Defender part numbers on engine swap... lost
Replies
4
Views
907
P7XES
P7XES
Back
Top