eas again

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
T

thegasman

Member
Posts
56
Location
ipswich suffolk
a friend of mine had faulty compressor pump so fitted new one and at same time replaced all orings on block and now all back together pump runs but no lift is there seems to be air in tank so my question is where do we look now for maybe pressure switch or non return valve if these can they be tested or am i on totally wrong route

oh and eas is unlocked

thanks for looking
nick
 
Open driver's door, and allow the pump to run until it shuts off. Then the tank is full. Close all doors, and it should start to rise.

If not search, read & study the 100's of posts about exactly this problem.
 
Have you disconnected the blue pipe from the compressor and tried to hold your thumb over it, if you can compressor is not making air, did you have the door open st start with this will stop the system trying to rise till the tank is full which can take quite a few mins then when pump stops close door and it should rise.
 
If no joy have a look in the technical archive, top left of range rover page for the post by the late Wammers:( on the eas system and follow the fault finding checks
 
tank was full of air and did close door but still no lift in bags at all its as if tank is full but not opening any solenoids to lift it up
thanks for quick reply
 
You must log in or register to reply here.

Similar threads

J
P38A p38 EAS - immediate drop of pressure
Replies
11
Views
477
Mark Piercy
Mark Piercy
Montyjohn
P38A Adding a valve to manually fill EAS tank and why did my pump fail again?
Replies
14
Views
825
Datatek
Datatek
pwood999
P38A Asthmatic EAS Exhaust Port !!
Replies
6
Views
605
pwood999
pwood999
M
Air compressor
Replies
12
Views
730
Mark Piercy
Mark Piercy
Flossie
P38A Eas issues
2
Replies
22
Views
1K
Datatek
Datatek
Back
Top