sergeantcookie
Active Member
- Posts
- 405
- Location
- Nantwich, Cheshire
Where can I purchase a new drag link from for a landy 90. The only ones I seem to be able to find are for a disco.
Cheers
Cheers
Drag link
- Thread starter sergeantcookie
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Vagrent
Yaaaar
- Posts
- 18,109
- Location
- Poiret West Sussex, Chichester.
hext
Active Member
- Posts
- 329
- Location
- Portsmouth
I've only changed both rods (track and drag)
I went for PM960 Heavy Duty Steering Rods for all Defender inc Ball Joints
good set, greasable ball joints...
what wrong with your current one?
I went for PM960 Heavy Duty Steering Rods for all Defender inc Ball Joints
good set, greasable ball joints...
what wrong with your current one?
sergeantcookie
Active Member
- Posts
- 405
- Location
- Nantwich, Cheshire
There's nothing wrong with the actual rod itself but i'm renewing the drop arm and a couple of the joints so may as well renew the tube also. Does that drag link come with both ball joints?
sergeantcookie
Active Member
- Posts
- 405
- Location
- Nantwich, Cheshire
Sorry not the ball joint I meant the connector to connect to the drop arm and the steering damper
hext
Active Member
- Posts
- 329
- Location
- Portsmouth
yep the drag link has one end ball joint the other end is threaded and bolts onto the bracket near the steering damper
sergeantcookie
Active Member
- Posts
- 405
- Location
- Nantwich, Cheshire
How hard is it to get the tube off the connector?
Vagrent
Yaaaar
- Posts
- 18,109
- Location
- Poiret West Sussex, Chichester.
I had that go on me RRC.
It was a complete 'see-you-enn-tee'
So I had to buy the whole tube and new ends.
It is slightly different on the rangie however.
hext
Active Member
- Posts
- 329
- Location
- Portsmouth
a bit of a pain but achievable there is split along the tube and a clamp holding it tight.
I dowsed it in WD40 12 hrs prior and again a few hours before
once the clamp was off
have a hammer at the ready tho
I dowsed it in WD40 12 hrs prior and again a few hours before
once the clamp was off
have a hammer at the ready tho
Last edited:
