Disco is dead

Lrt26 · Jan 22, 2012

I have a problem with my immobiliser

I'm not getting a switch live to the starter motor
I've been reading all sorts of things on what this could be and I was lead to believe it was the spider unit behind the heating controls but apon inspection I found I don't have one of these units can any one help cheers

robint · Jan 22, 2012

you have edc then !! there is a way to bypass this i had it done on my old 300 by cant remember how to do it now

jamesmartin · Jan 22, 2012

do you have a plastic box over pump solenoid or edc with wire on no4 injector and air flow meter in inlet pipe near filter

uncle albert · Jan 22, 2012

check wiring loom o/s inner wing and through bulkhead, thats were they play up on 200s. I had to rewire whole ingition and starter when mine went somthing burnt out behind heater so bypassed and isolated fault

Steve_R1979 · Jan 22, 2012

Could bypass the ignition switch and just use a press button to start it???

Would be MUCH easier than messing about with looms.

Lrt26 · Jan 22, 2012

Ive checked nearly the whole loom now,It looks ok also forgot to mention the red light for the alarm stays on all the time with the ignition on or off,

It' done my head in I've tried so many things but still nothing

jamesmartin · Jan 22, 2012

which system is yours edc or box on pump

Lrt26 · Jan 22, 2012

I'm not 100 % sure how can you tell sorry not ha the Landy long so havent got to no it yet....

jamesmartin · Jan 22, 2012

look at my earlier post

Disco is dead

Lrt26

New Member

robint

Well-Known Member

jamesmartin

Well-Known Member

uncle albert

New Member

Steve_R1979

Active Member

Lrt26

New Member

jamesmartin

Well-Known Member

Lrt26

New Member

jamesmartin

Well-Known Member

Similar threads