Defender Drop Arm Top Cone stuck in

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P

plook

New Member
Posts
87
Location
Sheffield
Hi, i'm trying to replace the ball joint in the drop arm of my Defender 300TDi and most of it has come apart nicely except for the top cone which won't move at all. I've broken a small vice trying to move it (i'm presuming it needs to go down and not up). I've tried heating it and whacking it with a hammer and it's only bending the top. I'm at a loss as to what to try next. Any tips would be appreciated.
thanks.
 
Can you force it out with a socket and g-cramp? Get a socket which fits through the hole in the arm but not the hole in the cone and squeeze it out...

Mind you saying that i had exactly the same trouble and had to end up getting a new drop arm (which comes with it all fitted) , which lead to a whole new problem of removing the old one! (once it's off the cone is far easier to remove!)
 
I spent about 4 hours trying to get the cone out and in the end decided that for £30 i'll just get a new arm, but the 34mm nut holding the drop arm on just won't budge and i've had full leverage on it. I was planning to try the socket and g-clamp tomorrow as i just found an article about it on the web, but there seems to be a top lip on the one in the picture that is not on mine - which might be broken. New drop arm i think, but how to get that nut off.
 
You must log in or register to reply here.

Similar threads

T
Rear spring stuck in upper seat
Replies
12
Views
465
Twinnie
T
T
Spongy(?) Steering
Replies
1
Views
208
tottot
tottot
W
My defender thinks it's a police car!
Replies
2
Views
327
vtwin
V
J
Help please! Electrical issue with 1995 Defender 110 County, 300 tdi
2
Replies
28
Views
798
GRATCH
GRATCH
dag019
Drop arm ball joint puller
2
Replies
32
Views
3K
KISSMYAURA
KISSMYAURA
Back
Top