D1 edc FIP fuel temperature sensor

Hello and before anyone says throw it away and fit a manual pump, I won't!
Fault detected on fuel temperature sensor, which I believe to be integral to the pump. Does anyone know whether this is accessible with / without removing the pump and if so is there a part number please. Alternatively would it be worthwhile obtaining a s/h pump and swapping the sensor onto mine?
Any advice welcome please....except telling me to go manual

My D1 parts catalogue shows various injection pumps, but it doesn’t show a fuel temp sensor as a replacement part, so you may be unlucky with the part number.
As for the other info u required I haven’t a clue, I’ve never been interest in Diesel engines

discool said:

My D1 parts catalogue shows various injection pumps, but it doesn’t show a fuel temp sensor as a replacement part, so you may be unlucky with the part number.
As for the other info u required I haven’t a clue, I’ve never been interest in Diesel engines

Click to expand...

Thanks for info.

if you can read the bosch part number from your pump send email to these guys https://www.ebay.co.uk/itm/Fuel-tem...injection-pump-VE-type-TDI-TD-D-/172718445080 , and ask if it fits (see the second picture with the diagram and read the whole page)... eventually ask them if that sensor fits bosch 0460414997 pump cos that's what's supposed to be on your vehicle (ERR3336) http://www.reparationinjecteur.co.u...97-echange-standard-0-460-414-997-c2x16434623

That's really very useful info, thanks.

I was thinking I had ERR6727 (based on vin) but have just established where the pump markings should be so will check when I can.

If it gave you ERR6727 based on VIN then that's it, as i didnt know the VIN i presumed it's ERR3336 so if it's 6727 then it's Bosch 0460414991

sierrafery said:

If it gave you ERR6727 based on VIN then that's it, as i didnt know the VIN i presumed it's ERR3336 so if it's 6727 then it's Bosch 0460414991

Click to expand...

Thanks replacement ordered (from Latvia of all places)

Did they confirm that it's good for your pump?

sierrafery said:

Did they confirm that it's good for your pump?

Click to expand...

Yes they did and I got a gasket set from them. Arrived from Latvia in two days. I'll post on here how it goes

Just remembered I said I'd give an update....replaced sensor dead easy just a couple of screws holding it in place. You will need a specific triangular bit to remove the top cover off the pump but got this as part of a bosch bit kit on ebay for £10