Freelander 1 Brake Pipe Renewal

Hello all.
I am looking to renew the brake pipes on Freelander TD4. Wondered if any one had done the job and could pass on any hints and tips.
I have the flaring kit and 25 ft of copper brake pipe. I have also invested in some inline connectors, given that some of the pipes may need to be replaced in two halves. Not to sure what the markings on the box relating to the braking system mean on the drivers side of the wheel arch F.R and R.R. and so on.
Any heads up before I start this job will be very welcome.
Thanks Gary.

https://www.landyzone.co.uk/land-rover/brake-pipe-flares-share-of-knowledge.347073/

Covers most of what I found out. I'd use cupro nickel as copper welds to fittings and is too soft to unscrew. Also you will need the correct flare tool, probably 2 to cover the types of flare.

Good luck, not hard, but get it right, it is a critical process and mustn't fail!!

Also worth a read....
https://www.landyzone.co.uk/land-rover/brake-flares-a-cautionary-tale.352733/

As always Andy. A really helpful reply from you. Big thanks!
Aim to change all the pipe system and with this info feel more confident.
Good of you to take the time to post the info.
Cheers Gary.