- Posts
- 1,497
- Location
- Somerset (but I'm a Landanna)
I want to add a bleed screw to the stat end of my bottom radiator hose and I'm looking for some parts I can use.
Ideally I just want a bit I can add between the end of the hose and the stat.
The hose has a 47mm (1.85") internal diameter. I've seen elsewhere 50mm external - either is probably close enough for a rubber hose.
So, does anyone have any suggestions for bits to make this with?
(Design attached)
Ideally I just want a bit I can add between the end of the hose and the stat.
The hose has a 47mm (1.85") internal diameter. I've seen elsewhere 50mm external - either is probably close enough for a rubber hose.
So, does anyone have any suggestions for bits to make this with?
(Design attached)
