BIGrabbit100
Member
- Posts
- 59
- Location
- Essex UK
Need help with serpentine belt adjuster pulley base. Does anyone know the torque for the spring arm that the pulley goes onto. NOT for the pulley but the spring housing that bolts to the engine.
Belt adjuster help
- Thread starter BIGrabbit100
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Anaconda
Well-Known Member
- Posts
- 5,407
- Location
- Thames Valley
Someone could help better if they know what vehicle you have.
BIGrabbit100
Member
- Posts
- 59
- Location
- Essex UK
94 disc 300tdi
discool
Well-Known Member
- Posts
- 13,743
I don’t know 
but if thats that what LR call auxiliary drive belt tensioner securing nut, then its 45Nm.
but if thats that what LR call auxiliary drive belt tensioner securing nut, then its 45Nm.BIGrabbit100
Member
- Posts
- 59
- Location
- Essex UK
Thanks for replying discool, that's probably the one as the pulley is a bolt. Thankyou so very much. It's just the squeaky sound is possible from there and I have grey grease coming out. Thankyou for helping.
BIGrabbit100
Member
- Posts
- 59
- Location
- Essex UK
Update - put in new pulley bearing and new water pump. P gasket leaking, so got new gaskets and removed...I found housing cracked top and bottom. Crack towards pulley housing location and a big piece broken off at alternator bottom bolt hole. However I tried to braised repair with no luck so chem welded it. Just need to clean it up and re drill. I popped into my trusted supplier "RST landrover" and got a used water pump housing for £20. At least I found the problem.
