B1D21-62
- Thread starter Caelis
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi All - I am a new Member and am hoping that someone can help with a problem. Both my remotes (fob) will only perform one function before becoming dysfunctional - If I lock the car, I can't unlock it. Once I have gained entry and have started the car then I can use any function on the remotes Once ...
I had a diagnostic done and the error code is B1D21-62
Cant seem to find a fix for this problem - Basically can't lock the car unless I intend to use Key to get in and set off alarm...
I had a diagnostic done and the error code is B1D21-62
| B1D2162 | Remote Control Switch - Signal Mapping Failure | A request was received from a programmable remote control key and the variable code counter reading was incorrect | Set up key synchronization with the remote control function using the key to start the ca |
Cant seem to find a fix for this problem - Basically can't lock the car unless I intend to use Key to get in and set off alarm...
Hi Caelis, welcome to a great forum.
I don't have the answer, but can offer advice that will speed up responses from the real gurus here.
I'm sure you will have replaced batteries in your remotes and tried the resyncing procedure before posting. If you add this info to your post - things will move quicker.
Good luck, kb
I don't have the answer, but can offer advice that will speed up responses from the real gurus here.
I'm sure you will have replaced batteries in your remotes and tried the resyncing procedure before posting. If you add this info to your post - things will move quicker.
Good luck, kb
brianp38dse
Well-Known Member
- Posts
- 19,998
- Location
- heathrow
Hello and welcome 
Best to ask over in the freelander section of the forum
www.landyzone.co.uk
Best to ask over in the freelander section of the forum
Land Rover Freelander
www.landyzone.co.uk
