Walshie1987
Active Member
- Posts
- 101
- Location
- Sheffield
Hi all,
Its just dropped cold enough for me to test the aux heater on my RR. So I've pressed the manual start, the blower starts for a few minutes and then nothing. I expected the FBH to kick in, but there not noise of fuel pumping or anything.
I looked under the bonnet to see if I could see anything obvious and I found the plug in the attached pic just hanging loose. I'm sure this is not a design feature so wondered if anyone could tell me if it's to do with the FBH and where it should go?
I will then address the issue why is was unplugged, guessing a fault somewhere but will see.
Cheers
Chris
Its just dropped cold enough for me to test the aux heater on my RR. So I've pressed the manual start, the blower starts for a few minutes and then nothing. I expected the FBH to kick in, but there not noise of fuel pumping or anything.
I looked under the bonnet to see if I could see anything obvious and I found the plug in the attached pic just hanging loose. I'm sure this is not a design feature so wondered if anyone could tell me if it's to do with the FBH and where it should go?
I will then address the issue why is was unplugged, guessing a fault somewhere but will see.
Cheers
Chris