RobCavendish
New Member
- Posts
- 58
Hello Everyone,
I am having trouble finding out how to reset a stored fault code in my air suspension ECU (93 classic). I have fixed the original fault with the system, but cannot clear the fault code. I believe that there may be a way to clear the code (and restore normal operation) without the use of TestBook, Rovacom or autologic.
Does anyone know whether this is true? and if so how to do it?
Alternatively does anyone know the details of the protocol used for talking to the diagnostic port?
I understand it uses a "k" and "l" line, much as does OBD-11, but does not run at10.4K baud as it pre-dates OBD-11 by a few years.
Thanks for your interest.
Rob
I am having trouble finding out how to reset a stored fault code in my air suspension ECU (93 classic). I have fixed the original fault with the system, but cannot clear the fault code. I believe that there may be a way to clear the code (and restore normal operation) without the use of TestBook, Rovacom or autologic.
Does anyone know whether this is true? and if so how to do it?
Alternatively does anyone know the details of the protocol used for talking to the diagnostic port?
I understand it uses a "k" and "l" line, much as does OBD-11, but does not run at10.4K baud as it pre-dates OBD-11 by a few years.
Thanks for your interest.
Rob
