Muppetdaze
Active Member
- Posts
- 382
- Location
- Thanet
Does anyone run these on an unmodified disco2? Somebody somewhere said they fit without any mods at all.
Currently 265 55 16.
Currently 265 55 16.
Disco 2 235 85 16 ..or..Yet another tyre question
- Thread starter Muppetdaze
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
I had them on an unmodified D1 for years, only needed adjust lock stops and trim rear arches under extreme articulation.
Can't see why a D2 would be any different.
Can't see why a D2 would be any different.
Pawl
Well-Known Member
- Posts
- 571
- Location
- West Midlands, UK
On our D2 I use them for off road competition. When I had medium rate front springs and only a 1 inch lift they were always banging into the front wing arch lips & outer edges of the wheel arch liners either at full articulation or full lock & less articulation. Finally solved with heavy duty springs & 1.5 inch lift.
They also rub the separate lower front section of the inner wheel arch liner & front bumper (pre- face-lift) until the wheel arch liners were cut down & tied forwards .
Remember, they are 2 inches larger diameter.
Steering lock was significantly reduced unless 25mm spacers or increased offset modular wheels are used.
At the rear, they're fine at 1 inch lift, would imagine they're inside the wheel arch at full articulation without any lift based minimal clearance with 1 inch lift.
They also rub the separate lower front section of the inner wheel arch liner & front bumper (pre- face-lift) until the wheel arch liners were cut down & tied forwards .
Remember, they are 2 inches larger diameter.
Steering lock was significantly reduced unless 25mm spacers or increased offset modular wheels are used.
At the rear, they're fine at 1 inch lift, would imagine they're inside the wheel arch at full articulation without any lift based minimal clearance with 1 inch lift.
