2 starters both clicking and not engaging

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
taylorslandy72

taylorslandy72

Active Member
Posts
224
Location
bristol
Hi all, just wired up my starter, solenoid clicks away and nothing else, this happens with both starters I have. I have tried these on the battery prior to fitting and they both shoot in and out as they should. 90 2.5n/a in a series 3
 
Hi you can try a jump lead direct from the battery to the spade terminal , just don't touch any where else with it , I use a jump lead from the battery then connect it to a smaller wire , so there is no chance of it touching anything else , you could always fit a spade connecter to a spare piece of wire , make its in neutral as well , motor should turn engine over , be careful
 
First i'd use a jump lead from the negative terminal on your battery to the engine - then try to turn the engine over using the key - if that works ok your problem is the earths from engine/gearbox to chassis to battery ;)
 
pdennis30 said:
Hi you can try a jump lead direct from the battery to the spade terminal , just don't touch any where else with it , I use a jump lead from the battery then connect it to a smaller wire , so there is no chance of it touching anything else , you could always fit a spade connecter to a spare piece of wire , make its in neutral as well , motor should turn engine over , be careful
Click to expand...

I'm going to give it a try, thanks
 
You must log in or register to reply here.

Similar threads

N
TD5 Cranking Not starting - Solved
Replies
18
Views
2K
NdG1977
N
M
Both FOB not working, car would not start
Replies
3
Views
959
maurizio82602
M
Flossie
Old car electrical question.
Replies
2
Views
716
J_D
J_D
D
Non-starting 1997 Freelander L-series
Replies
5
Views
274
Freddie17
Freddie17
B
Output shaft splines.
Replies
7
Views
440
Brylton
B
Back
Top