110 exhaust fittings?

Exhaust is hanging off my Defender.

Need some advice...

Firstly, mines a high cap but I assume they are same as any 200tdi 110?

Secondly, phoned Paddocks as theymare one of the few who do decent postage to NI.

They reckon they can supply front downpipe, straight through middle pipe, rear pipe but no fittings?

I have rubber mounts and gaskets will be easymto get...but can anybody tell me what else is needed fitment wise for doing the whole thing?

Also, just spotted my entire back section is not connected to anything and can't see any bracket on chassis...anybody know what bracket I need to order to correct this...I assume something should be there?

Any help appreciated. Ordering up stuff before weekend as taking off the road for 2 weeks to try and get it in some sort of roadworthy state again.

you might want ntc3608 clamp and 6 m10 nuts and washer

errr nothing, assuming you have the original bolts.... I didnt use any gaskets either as I read it was best to have clean seal. The back section should just have a hook below your rear cross member which the rubber bit hooks onto... maybe it broke off.

Thanks James! I assume just few rubber mounts and gaskets as well then?

HYBRIDNI said:

Thanks James! I assume just few rubber mounts and gaskets as well then?

Click to expand...

are you old rubber mounts worn

Everything's worn!!! And bolts are going to need cut off. Yeah bracket must have broken off