1 out of 4 = 3 buggers needing advice

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A

Alternativegem

Member
Posts
14
Location
Kent
Hi hi,
Just got me my first Landy, a P reg 110 county, and attempted a front bumper removal, WD'd liberally, but 3 of the four bolts snapped off at the start of the thread inside the front of the chassis . Am I off to buy slitting disks or can anyone advise on another method? Btw bumper US
 
Every bolt you fit/refit always grease it, not that messy copaslip just ordinary grease.

If you look up underneath you will see the captive plates mentioned by tottot.
 
tottot said:
Common problem, the bolts end up corroded in the captive nut plate at the bottom of the leg. As bumper is US chop it off and gain access for removal of old plates. You can get a stainless bolt kit. I fitted a galvanised bumper on mine.
Click to expand...
Thank you muchly
 
You must log in or register to reply here.

Similar threads

Skyisthelimit
No impulse on Discovery 1 1991 model V8 3.5 right hand drive.
Replies
12
Views
812
classic kev
classic kev
Tango91
  • Poll
Disco 2 Things I wish I knew when I took the body off (99 D2 TD5)
Replies
8
Views
3K
FlatbedPilot
FlatbedPilot
J
90 vs 110 for a family of 3
2
Replies
26
Views
3K
Rotherham Rover
Rotherham Rover
Software-and-Swarfega
Series 3 - Angle of steering column as it exits bulkhead
2
Replies
26
Views
4K
Software-and-Swarfega
Software-and-Swarfega
karlp606
Think Of Selling....With Good Reason...Puma Upgrade :)
Replies
2
Views
1K
lightning
lightning
Back
Top