Fit two just incase you get stuck and you can't access your only recovery point.

I have but it is covered.

Whatever we all think about it, the Discovery Sport will sell well.

If that's happening, the metal inside the rubber has "gone". The only solution is to replace. Large Car Rubber Door Seal - Van Boat Camper Caravan - Best price on eBay! | eBay

+1. Take it off. Tap it softly with a rubber mallet on the side along the loose section. Refit.

Loosen, move, tighten? :p

A pain in the fecking arse!! Have a look at my build thread, they are in there somewhere. :eek:

Look at the inside - fibreglass will look like Shredded Wheat. :)

:behindsofa:

Like :D

It's amazing how obvious the answer sounds when somebody else says it! :o:o:o Thanks Paul. :D

:hijacked::hijacked::hijacked: A quick hijack - apologies. With Polybushes (genuine or otherwise), there is a collar that sits on the inside. My question is..... On the bushes where there is rotational movement (rear of trailing arm, A-frame, etc), is the collar held in place and...

M5,M6,M8,M10 A2 Stainless Steel Flange Hexagon Hex Head Metric Bolts / Screws | eBay £1.40 for ten stainless - posted!

I've just had my OS sill cut out and replaced with a YRM repair panel and B Post repair. Also replaced was the NS rear wheel arch. I supplied the parts. £240 cash. saved me a huge ball ache of a job - before people say buy a welder and learn to weld, I have and I can, it's just the wrong time of...

Do you mean the bench seat (seats 3, 4 and 5) or the dickies (seats 6 and 7)? The bench seat is eight M6 bolts - ebay? 20mm should be fine as they just protrude out of the captive nut under the body.

It's running mis-matched tyres, budget ones at that. A sure sign they have kept the spending down. What else has been done on the cheap. Niggling apart, check that boot floor!

Sorry Bud, can't help you. But I do have a 2.8TGV with a VNT and it's superb!!! Just grunts from 800rpm - quite difficult to feel the turbo "kick in" as it's there all of the time. Hope yours is just as good. How much did you pay for the turbo?

You can't leave us drooling and not phost any photos! :laugh::laugh:

+1. David at Llama was really helpful.

I lost the connecting bolts in the process - ordered some more. Can't get the fecking ball joint out so keeping my own when I swap it. Thanks again. :clap2::clap2: