easy to change, single socket job!, if you smear them in washing up liquid it will make em easier to locate and close the clasp.

sounds like the bags have gone pourus, replace them.

and i agree with them, Cooper or General tyres are much better value:)

OK, to shake things up a little! Most 300's will have had a timing belt replacement by now. Early 300's had a different timing belt assembly which was no good. the bad design caused belts to break prematurley. the difference is essentialy in the bottom pully and the idler; the early...

handbrake turn a disco.... you serious?

pop the headlight out on the nearside, you'll see the release cable at the top of it's socket, attack from there. headlights should just pop out of their little eyeball clamps.

What were your exact symptoms for this fault? I have a fuel guage that dont read correctly, i have also changed the pump unit and it's been the same for both pumps..

Remember to scribe nice clear lines on the UJ's and the splines when you plan to pull it apart. so it can all go back together the same way. GKN: TVC100010 is the UJ part number (I got one right here on my desk!) a large vice, a few pound coins and some circlip pliers and they're easy enough...

Your right! I might take a grinder to it and remove the trailer!

the bumper will fit i'm sure, but whether or not you'll get everything behind the grille with your autobox cooler... ??

manual

General Grabber AT2's are my personal choice

on a land rover, every bump and scratch usually has a fond memory attached.

I wanted a subtle winch setup on my 300. This is a Superwinch EP9 mounted in a guardian bumper. it's so close coupled that the winch is entirley behind the grille and the bumper is closer than the original LR one.

dont feed it after midnight!

Every time I start my TD5 it runs lumpy for the first couple of seconds, I thought this was down to the 5th cylinder needing just that little extra time to warm due to not having a glow plug at all?

Land Rover's practical joke department are proud of that 'feature' on the TD5!

whats the history of your 'new' motor? if it's ever done any deep wading without the front timing cover wading plug, then the belt will have a significantly decreased service life!

Just the fact that you've actually offered grease into the prop is more than most people do...! Hopefully the new grease has forced out the old grease and any grit or particles with it. But there is only one way to be sure and that is to do it on the bench like MHM said.

the Rave CD's are PDF. search and you will find.