I just ordered a plain unlock/lock single key from ebay, took it to the smith. To get fitted. And transfered the chip from my old lock to the new one. Only cost me $20 US dollars.

I didnt mark the prop when connecting it to the vcu. Alot of people say that you need to mark your prop before removal or install it or it will throw it off balance. When i replaced the bearings my prop shaft wasnt align perfectly in fact it was off by 2" inches. I went back and refitted it but...

That cray because mine was of by 2 inches and it didnt cause any problems. When i changed the bearing i didnt mark the prop and vcu and everything work out fine. Glad your noise is gone tho.

Winning!

Did you try the wheel bearings? Your car rumbles at certain speeds and rumbles again when slowimg down right? Mine did this last week and ended up beign those bearings.

Fitted two new wheel bearing. Vibration and noise all gone now. Just need to blead the dam thing right. Has a bug air lock on.

The battery issue was due to a loose nut on the batter wire deal. I can get around swapping coils to check if thats the issue. I know ill need a new coil for sure because the plastic piece on the bottom of the coil (5th cyclinder) is cracked. As for the ecm i dont jnow where thats at. I can...

Replaced the rear spark plugs. Didnt have time to replace the front ones. Will get to them tomorrow. Also need to get two new coils

Changed cylinder 6 spark plug. engine service light still on. Can it be a coil thing now?

P0306- cylinder 6 misfire P0500- vehicle speed sensor A P0606- ecm/pcm processor fault P1471- short circuit to battery P1472- electrodrive fan operation failure passanger side short circuit to ground P1562- battery supply check P1605- keep alive memory test failure

Thank you :)

Found a forum with code list here for the range rover those it also apply for the freelander?

Sup guys need to decript these codes please. P0606 P0306 P0500 P1471 P1472 P1605 P1562

What wheel bearings in the cv joint?

Does your freebie vibrate at around 30-35 mph like mine? Ive done 5 new tires new prop bearings and U-joint. I think i might have to refit U-joint sometimes that can be it. Hope its not a cv joint.

Got 5 new michelins all season 235/55/17 for the girl. Im getting a wierd vibration thoo. I know its not the prop bearings they were changed about a month ago and the tires are new. Only thing left is prop shaft or the brake shoes might be f-up and touching the rotor deal. Any input?

Awesome advice thanks hippo :) ill have a look tomorrow morning

I have a similiar problem with abs hdc and tc amber lights. Just changed brake light switch and no luck. Will try abs sensor just need to know what im looking for :) any help plzz

Three amigos still on dam. Is the plunger supposed to be springy? Where is this ABS sensor??

Awesome thanks man :) i though it was a replacemet wire haha you rock bud :)