If you put the description by the code (saves us looking) we'll give you idea's on the possible fix.
 
P0306- cylinder 6 misfire
P0500- vehicle speed sensor A
P0606- ecm/pcm processor fault
P1471- short circuit to battery
P1472- electrodrive fan operation failure passanger side short circuit to ground
P1562- battery supply check
P1605- keep alive memory test failure
 
try deleting the codes and see which ones come back

there may be old and no longer valid ones in there
 
P0306- cylinder 6 misfire
P0500- vehicle speed sensor A
P0606- ecm/pcm processor fault
P1471- short circuit to battery
P1472- electrodrive fan operation failure passanger side short circuit to ground
P1562- battery supply check
P1605- keep alive memory test failure

I like the code from the RAVE since they have the actual mapping to the Siemens 2000 ECU used in the NAS version. more details below. Anything happen to you ECM (ECU) or wiring loom? Any changes lately? I am talking about P0606 here.

FREELANDER 2001 TO 2004 MY
ONWARDS
WORKSHOP MANUAL - SYSTEM
DESCRIPTION AND OPERATION

Publication Part No. LRL0351 NAS - 5th Edition

Page "18-4-32 DESCRIPTION AND OPERATION" (page 69 in my pdf)

P0306- Cylinder 6 Misfire detected
P0500- Vehicle speed signal Signal implausible
P0606- ECM Processor fault
P1471- VIS balance valve motor Valve always closed
P1472- VIS power/ butterfly valves motor Valves always open

Those below are from the JATCO transmission it seems

Page "DESCRIPTION AND OPERATION 44-37" (page 154 in my pdf)

P1562 - Power supply voltage 10 – 16V engine idling Out of range
– Check wiring and connections and battery condition

P1605 All EAT ECU EEPROM EEPROM updated by EAT ECU following ignition off and before main relay opens Error flag set
– Clear flag. Power was disconnected from EAT ECU before main relay opened
 
Last edited:
The battery issue was due to a loose nut on the batter wire deal. I can get around swapping coils to check if thats the issue. I know ill need a new coil for sure because the plastic piece on the bottom of the coil (5th cyclinder)
is cracked. As for the ecm i dont jnow where thats at. I can check if i know what im looking for :)
 
Last edited:

Similar threads