Hi jj Are you any good tracing wires from a wiring diagram using a circuit tester lamp? I think this is what you need to be doing and ticking off where there is power on the drawing. This process would reveal the problem. If this isn’t your bag I would recommend you call an auto electrician...

Welcome 2wd Jim. You name it someone on here has done it , twice !

Hi Bob I don’t know how your getting on or whether you’ve cracked the problem but I thought I’d chip in. The vehicle will self level(lower only) to the lowest corner over night which kind of masks the problem. If however you can leave the door open over night it will not do this and if you have...

Welcome to forum Bob. Ownership is a lot easier with combined knowledge

Hi Danny Welcome

Hi I had an intermittent relay problem on one of my 110,s I put a light bulb across the connectors on the rear screen so i knew if power was getting there. This helped me isolate the fault as I knew I had power to the switch and the relay

Hi Jj Just read your post with interest. An intermittent fail is so frustrating and I recently had one on one of my motors. I found it very useful to use a witness light or buzzer rigged to the wiring circuit in question to determine whether the feed had disappeared when it cuts out. You can...

Welcome Damon That’s a mighty fine vehicle.

Hi Kev Do you weld yourself? Fancy a go? I use cereal packets(empty) and for a patern. Based on where you need to cut back to. It’s a brill skill to learn . First you become an expert grinder but you soon find you are delivering a very respectable standard. Free lessons in Blackpool

Hi Brad, any piccies of the damage for us technically under nourished folk. ? I’m starting to venture into plastic welding and finishing. Not as expensive as you think.

Hi Stanley Welcome to the asylum. I’ll see you in the technical forum for FL. Safe journey.

Welcome David, your obviously insane enough to join the club. Did I say that out loud?

I’ve done a bit of measuring and I do believe they will do the job mighty fine. I’ll pm my address and you can let me know what I owe you. Thanks again Rich

Must be a slow worker if he’s still alive

Hi Steve I’ve just been through the same thing. Get a landrover specific diagnostic tool plug it in. Post the results and the guys will walk you through the process. Bon voyage .

Well my eas quest continues. Thanks for the help so far proving two heads are better than one half. Two more faults found. Cracked bracket securing end of height sensor to rear wishbone if they are still called that. When checking the reservoir solenoid under the car I suddenly became aware I...

That is brilliant. Did you design it yourself?

Good point !

Hi Colin. Welcome. I can’t tell you what I’ve got as I hate to see a grown man cry Enjoy

Can’t resist this: Student pilot snags an aircraft and writes unfamiliar noise in port engine. The tech who dealt with the snag wrote: Port engine run for 30mins, noise now familiar !