Here it's propshafts and VCUs back on until next spring. Good luck with MOT. Dag..

Hi and welcome, This sort of sluggishness crops up fairly often and there's plenty of info on the forums. Download 'Rave' via Greenoval site for reference. Clean out or by pass EGR and block off small vac pipework. If there is no excessive smoke during acceleration then I would...

Hi and welcome, Search the forum and make a list of things to check etc: E.g. Auto transmission fluid should have been changed at 60k How old is fuel filter? Engine crankcase breather? (real name: crankcase depression limiting valve) very important. Good luck.

The main live cable to the solenoid has to be removed and you should disconnect the battery first, however this means that the radio code will be lost. Therefore if you do not have the radio code you will have a problem, we carefully disconnect the solenoid live cable and shove it inside a...

Спојница хидраулике користе дот 4 уље за кочнице &#1080...

Aleks. We would like to help with your technical problems but are having difficulty in understanding the translations. Tip određeni član TEKST te želja za prevesti ovdje. Aleks nama sličan za pomoć ipak određeni član prevod nije dobar

I would have expected other symptoms if the cause was due to excessive wear in steering/suspension components e.g. knocking noises or unusual vibration felt through the steering wheel. In addition to tracking errors i.e excessive toe-out, another cause of inside edge tyre wear is incorrect...

Ignition switch faults are becoming more common as these Land Rovers get older. Use a 12v test lamp or voltmeter at the starter motor solenoid actuating cable (the thinnest cable) each time the key is turned to the cranking position voltage should be registered, if so, then the ignition switch...

The ARB should have a blob of weld either side to prevent it sliding to one side or another, These 'blobs' tend to fall off over time and a reasonable bodge is to use a 'Jubilee' clip against a split washer around the ARB just next to the affected ARB rubber mount.

I would change the fuel filter and run some 'Millers' through the system.

The clearance required is approximately 6mm.

The MOT centre should have given you a print-out from the gas analyser: can you advise: HC ppm level CO % Lambda reading

Hi, Recon VCUs are reasonably priced now but before spending any cash, I would drain the IRD oil through a fine filter e.g. tights, and carefully look for any metallic lumps which may be parts of broken IRD components. You could also remove and inspect the IRD output shaft and inspect the...

Try jump leads from a known good battery, if your engine then starts normally then your battery is probably faulty. Otherwise check all main cables from battery are clean and tight, particularly earth cables. Another possibility is that the contacts within the ignition switch are failing (an...

Bonsoir

The taildoor solenoid has an adjacent taildoor latch position sensor which signals latch position to CCU. The latch position sensor would appear to be sending incorrect information as the CCU is assuming taildoor closed, whilst it is in fact still open, and therefore returning the taildoor...

This very common problem area is well overdue a 'sticky' definitive guide to diagnosis and rectification.

We opted for the much simpler and cheaper Unisys radio switched relays to activate both FBH and high speed blower fan relay using 'Rave' wiring diagrams which are excellent. The driver simply presses the remote button 5 minutes before departure.

Well done. Having experienced similar some years ago we now withdraw the sensors during the annual pre-season servicing and apply a smear of Copper-slip and of course due to sods law coming into play we have had no further sensor failures on any of the fleet since!

I'd guess that a fuel pump is giving up. Early 03 may have two pumps: in tank and engine bay inner wing below fusebox. Later 03 has one pump behind plastic liner o/s/r wheel arch. If the engine won't start leave ignition 'on' and try tapping the pump, a faulty pump will usually then burst into life.