Brake switch reset It cannot be the abs system making the car run in 4 cylinders All even numbers are missing

Sorry on a phone in a layby done that no difference seriously thinking of scrapping it so ****ed off

I meant that as a question :)

Only a few screws

As I am now out and on my phone can anyone do me a quick idiots guide and I'll do it in a layby

The brake lights come on is there another way of setting the switch?

Replaced rear wheel speed sensor as that was coming up as shorting new battery fitted both made no difference still have abs light and tc lights on and the care is saying traction failure and abs fault I'm really stuck

Got this from the nanocom today Rough road signal implausible drive cycle a occurred Could this cause the rough running as it goes into limp home mode ? It also says ABS fault

Well still stuck nanocom not much help but I think that could be user error It is definitely missing as opposed to choking up is there anyway of checking the air hoses for leaks ? I know if they are under pressure they will bubble but what about the inlet side ?

i dont know how would i check ?

Exhaust smells very rich seems to have pressure

Tried the maf test even swapped them with a spare runs like a pig Exhaust next

I replaced plugs coil packs and leads will do wammers test next how do I check for exhaust restrictions (without removing them) more to the point can I ?

I am not the brightest today no :) Did a compression test all 8 were @ 175psi or over seems to run ok cold then choke up when warn As though it stops running on 2 or three when warm ?

Engine was running I disconnected the maf and it cut out does that mean maf is buggered ?

Can I drive it with the maf disconnected ?

So I did it sounds like a burbling V8 but now I think about it and get more sensitive to it it seems to be missing more and more Can I test the maf with a meter ?

Don't think drive train as it sounds rough too though I am getting the abs and traction lights on no brake light though

Slightly better on gas

Right changed the maf put on new coil packs ( that was fun ) still no power at all any ideas I do have a nanocom but don't really have much luck with it