I'd guess Scottish Border's, near the Solway firth area

Fog light working but it put up a fight ! Turned out to be a faulty supa plug.

Try extra wheel steel nuts at the back, the thin nuts you describe are usually found on discovery's or the post 2007 pressed steel mount

I have Nolden's in mine, would not say they are cost effective ! Don't expect the brightness improvement to be equal the cost. Mine should be like midday Sun ! But they aren't ;)

Milliput

Your 300 fuel gauge will be fine, just need to extend the wiring. I've put a plastic puma tank in my 200tdi (disco fuel pickup and sender). Rear cross member tub bar is great as it gives you adjustment from the chassis to tub. Good luck with the project as you will unfortunately have lots of...

Apparently flat started late 1988 production until the TD5 got a ribbed roof

Was on in 1990

More electrics, takes ages to check but reversing light works, had to rework carling lights for sidelight operation

Next time wrap the webbing around the frame one turn, stops it pulling off the pop rivets so easily

Dipped/full beam, stop-tail lights, number plate light. Horn, wind screen washer pump little bits but coming on

Depends what and where your going. Deep muddy gritty water is not your alternators friend, also very good at getting in all the holes in the chassis , but finds it difficult to get back out. Also clean out the bulk head and wings of debris as it holds moisture exactly where you don't want it.

Yes saw your post, you need the timer relay or you will burn out your glowplugs

I have sidelights and Indicators ! Dash in, Windscreen wiper motor and drive to spindles works.

Sorry its a Disco 1

Will find out tomorrow if one I know of is for sale

And the bit that land rover stamped the chassis number on :D

Check to see if the drivers dumb iron has so much corrosion that its had to be ground right back, and patched up about 2cm x 14cm.

Started building up the dash. Put the carling switches in ! Took a picture and realised the drivers window switch cover was on upside down, now rectified.

Yo don't need spigots, lots of aftermarket wheels are bigger than the hub.