Yes John and I will be on channel 10 Sam

I've made a decision to go John so should be there about 10am or soon after :)

I'm thinking about it, a lot of my m8's are going to Donny show but I'm not as don't need anything and it's a bit small for a day out, might see you there :)

I've got a set in 285/75 16 flavour, found them a great all rounder, quiet on the road and good offroad as in lanes but of course fall down in gloopy mud ( but so does very other tyre unless it's an extreme mud tyre, found them ok on wet roads but never tried them on ice or snow as havn't had...

Thanks for all the advise, will start the install as soon as I get time, will try and do a few install photo's but I'm usually not good at that as get carried away with the job in hand and forget to take photo's

Thanks that gives me a starter for ideas :)

I'm fitting a webasto air top 2000st with digital timer/controller if that makes any difference

I am about to fit a night heater for the laning weekends as sleep in the disco, I've never fitted one before and wondered if anyone can give me any pointers o. Best place to fit ect, my disco is a commercial so no rear seats fitted, also I do quite a lot of Offroading/laning and was wondering...

Can't really help you with manufacturer, do look a lot like a compomotive design, the b 1570 y bit is probably the design code 'b' is for wide 1570 is the loan rating 1570lb and 'y' being the speed rating?

It's just so wrong, think its just too easy for people to claim for stuff that's no real, no wonder we pay so much for insurance these days, kept getting phone calls saying that money had been put to one side for my partner to claim for injuries and distress due to the accident, kept telling...

Just got my renewal from flux, it contained accidents and convictions and this is the first time that I have the info about a bump that happened on 09/2013 I was reversing back into a parking space at the side of the road and bumped into a car pulling out of a space ( my fault thought he had...

This is mine :) It's a '98 on a 's' plate so a very late 300tdi It's raised a little and also a few mods like :- Bit of a paint job Full width Intercooler 600x300x75mm with pump tweaked to suit Ashcroft air locker front and rear Caster corrected arms front and rear Custom length wide...

Sorry never thought of using the report button, will do if I come across anything like this again, gutted that they got ripped off, defo report to rac, I work in the breakdown recovery business and sad to see this type of thing happen

Think you can put a longer stud/bolt in aswell as there will be some thread left below the original stud/bolt ( just a thought that might help )

Unfortunately I'm too far away to help out, sounds like it may be rocker shaft broke, usually due to stud pulling out of head, I'm only guessing though of course, hope you get sorted, I'm sure there's someone closer that will help

Looking good :) Keep thinking I would like a cage on mine, but think ' do I need one ' will it make it top heavy ? Would like one for protection from trees and the like so have been thinking of just putting rub strips ( like tub rails you get on a truck cab ) ally box section along roof line...

Terrafirma +5's in action lol

If you heat the spigot with a blowtorch it won't tanker enough heat to damage the seal never mind the bearings, you don't near that much heat, you'll put enough heat with a angle grinder anyway

The spigot has got a locking sealant on it, heat it up to break the seal then use a bolt down the threaded centre, as you tighten the bolt it will push the centre spigot off

Would make it interesting :) had plenty of rain here in the last few days