jedi
Well-Known Member
Hmmm you extended the wires did you?[emoji4] [emoji366] .......have you used wire of the same rating/thickness?.....if it's too thin/underated it will act like a resistor and slow the motor down...these motors draw some hefty currents, also if the extended wire is under rated it will get quite warm to the point of melting[emoji4]
Also you could pull the casing of the motor and with no window attached turn the armature....you should be able to turn it with ya fingers...this will prove that the mechanism moves freely and is OK.
Also you could pull the casing of the motor and with no window attached turn the armature....you should be able to turn it with ya fingers...this will prove that the mechanism moves freely and is OK.
Last edited: