check fan belts etc aren't rubbing If it's doing it whether it's moving or stationary it usually points to engine related problem.
 
redhand said:
check fan belts etc aren't rubbing If it's doing it whether it's moving or stationary it usually points to engine related problem.
Click to expand...

My brother is supposed to be coming having a look at somepoint. Il get him to stick his head under the bonnet whilst i rev her us. See what he thinks. So far he has suggested an engine problem, a clutch plate priblem or a flywheel problem.
 
metallicachick86 said:
My brother is supposed to be coming having a look at somepoint. Il get him to stick his head under the bonnet whilst i rev her us. See what he thinks. So far he has suggested an engine problem, a clutch plate priblem or a flywheel problem.
Click to expand...

+1 on that diagnoses..
You should only change from hi to lo at very low revs and when stationary. with all wheels stopped.
 
metallicachick86 said:
My brother is supposed to be coming having a look at somepoint. Il get him to stick his head under the bonnet whilst i rev her us. See what he thinks. So far he has suggested an engine problem, a clutch plate priblem or a flywheel problem.
Click to expand...
flywheels dont usually give issuses, clutch plates do which would tie in with clunky gear change ,though you may have more than one issue ,in gear with clutch pressed means no drive at all through gear box ,in neutral gear box is still turning
 
metallicachick86 said:
Nope lol. Need it for my holiday in 4 weeks and have no pennies due to paying 500 to get it back on the road a few weeks ago.
Click to expand...

If it is Transfer box. I have a spare that you could use until such time as you can source a replacement.
 
id definately be looking over the engine ,fan belt off and try ,rocker cover off etc ,does it run ok or lumpy
 
metallicachick86 said:
Seems to run well enough. A bit shaky when pulling away sometimes but this has happened since the new clutch was fitted.
Click to expand...
its hard to tell from recordings but sharp knocking can come from broken rocker or bent push rod etc but would effect running ,same noise can come from vac pump but no effect on running its a matter of working along till your left with only possibility ,shaky ?should be smooth with new clutch ,that may lead you to suspect to clutch issue ie not fitted correct or faulty
 
The day after the clutch was fitted, the new bearing collapsed so theu had to take it all out again and refit a new bearing. They checked it all and said it was fine. Its a land rover specialist who fitted it
 
You must log in or register to reply here.

Similar threads

R
Freelander 2 (LR2) Intermittent engine fault
Replies
8
Views
1K
RedMike60
R
J
2003 Disco 2 4.0 Thor Auto - strange accelerator behaviour - fixed
Replies
1
Views
810
JohnKeane
J
N
TD5 Cranking Not starting - Solved
Replies
18
Views
2K
NdG1977
N
J
Kenlow wiring mess
2
Replies
22
Views
1K
dag019
dag019
Skyisthelimit
No impulse on Discovery 1 1991 model V8 3.5 right hand drive.
Replies
12
Views
835
classic kev
classic kev