Got my 1999 TD5 Disco MOTd,So that's sorted for another year i noted on the mot paper that last year i did 3,500 miles,The mot place that i take it to each year,, I say how much this year the answer that comes back has been the same for about the last 4 years £35.:cool:
 
Oldseadog said:
Is that anywhere near Holmfirth in God's County of Yorkshire? :D:D
Click to expand...

It is indeed we are about 12 miles away, the Doris and I usually end up there on a Saturday morning.

Sorry about the extra e, it's in the Holme valley, with the e, it gets a bit confusing sometimes when you're hard of thinking :eek:
 
Last edited:
Filled the holes in bodywork where old window grills were.

Oh and tried to start it....fail, after 10 mins of trying junior says have you turned cut offs off. Doh
 
Replaced the washers on the power steering pump supply pipe - hopefully it will not leak anymore!!

Also fitted two of the new hinges before the rain stopped play; the drivers door shuts and opens properly now!

I'll get some pics up tomorrow.......
 
fitted my front headlining,noticed the rear heading i picked up was infact a middle lining outta 110, fitted an interior light and a rear interior strip light out of a caravan & also finished fitting my raptor dash. oh and also snapped and shreaded my bloody fan belt :censored:
 
Highly technical stuff- sprayed WD40 on every bolt holding my steps in place ( and there's not as many of them as there should be :eek:) in the hope that if I carry on doing this for a week I will be able to remove them next weekend
 
110woman said:
Highly technical stuff- sprayed WD40 on every bolt holding my steps in place ( and there's not as many of them as there should be :eek:) in the hope that if I carry on doing this for a week I will be able to remove them next weekend
Click to expand...

try holding the spanner/socket at the end of the long bit :rolleyes::behindsofa:
 
Sprayed the front bumper n light guards with primer n cut some chequer plate out for bottom of doors, it's starting to look good now!!
 
Fitted a new seal to the O/S swivel. Can't see it lasting though the balls are pitted. I think I will need to save up and refurb' both ends of the front axle.
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
475
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
575
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
840
Knappster
Knappster
Mooky
Replacing thermostat
Replies
8
Views
256
Forrest Gump
F
I
Re-coding of ABS Module after repacement
Replies
10
Views
923
invisible999
I