mikescuba
Well-Known Member
You mean, like this? This was the old hood I have just removed
Now that's how a Defender should look. Nice shot.
cornish rattler
Well-Known Member
Not on landy but spent a couple of hours sorting my new bench out wasn't realy happy with how the bench drill and vice was positioned so swapped them round then tomorrow i will move my roll cab to the opposite side of the bench as its too much in view when the garage door's are opened, can't be seen if it was at the other end of the bench in the corner 
mikescuba
Well-Known Member
If its from Paddocks I went through three of them in a very short period of time.
started to make a tablet bracket for the disco. pics tomoz after painting.
viamphie
Active Member
Yep it was. They're sending out another.
It wasn't a ****part either. If it happens again il have to source one elsewhere.
viamphie
Active Member
Nice.
Why not go for a windscreen mount? You wouldn't have had holes in the dash
a2dds
Active Member
Drove it - Towed my friends car down the road after he wrote it off poor chap. And stuck a new number plate on me new flatbed trailer ready for work towing staging next week! Picked up two 20l jerrys from work, ready to add to the two 100l bowsers for all the red I need to move around. Big job next week - hopefully the old girl can put up with it all.
poor chap. And stuck a new number plate on me new flatbed trailer ready for work towing staging next week! Picked up two 20l jerrys from work, ready to add to the two 100l bowsers for all the red I need to move around. Big job next week - hopefully the old girl can put up with it all.
landrover11019
Active Member
Changed the rear radius arm bushes.
Had to chisel the rubber doughnuts out to get to the nuts and bolts.
On one side someone had welded the bolt to the axle bracket!!!
Took 6 bloody hours in total.
Had to chisel the rubber doughnuts out to get to the nuts and bolts.
On one side someone had welded the bolt to the axle bracket!!!
Took 6 bloody hours in total.
