replaced my starter motor, pig of job but all done now.



Turbo is now making a strange noise, sounds more like a squeal rather then a whistle, thought i found the problem with a leaky hose but it still seems to be making the noise. Any ideas? its been one thing after another this month. tis deciding to fall apart :(
 
Last edited:
a2dds said:
replaced my starter motor, pig of job but all done now.

Turbo is now making a strange noise, sounds more like a squeal rather then a whistle, thought i found the problem with a leaky hose but it still seems to be making the noise. Any ideas? its been one thing after another this month. tis deciding to fall apart :(
Click to expand...

Wait! never fear! i was a bit peed off so went and had another look before the light ran out. Turns out a hose clamp was damaged and had got stuck so felt like it was tight but actually wast, had a spare so changed it over and turbo is nice a quiet and hissing healthy :) Happy man now :amen: :nospamhere::bounce:
 
sorted out the slave cylinder, it would appear that the R380 slave cylinder thread is the same as the LT77 master thread and the same again as the series 3 slave thread!

But the LT77 slave thread doesn't fit either…………but its sorted now
 
Nothing to the landy but went to cheshire show and got to see a load of twisted land rovers really nice fellas started up a 6.2 v8 110 with 520 bhp made the ground shake especially with the £137.000 price tag ouch. Oh and nice chavtastic 90
 

Attachments

  • 20130619_155644.jpg
    20130619_155644.jpg
    268.7 KB · Views: 230
danny6801 said:
Nothing to the landy but went to cheshire show and got to see a load of twisted land rovers really nice fellas started up a 6.2 v8 110 with 520 bhp made the ground shake especially with the £137.000 price tag ouch. Oh and nice chavtastic 90
Click to expand...


Lucky sod, nice day for it an all, bet you got red ears:D
 
Got first coat of new paint on the 110, ran out of time to sort front axle oil seal...all down to tomorrow now for next coat of paint and finish off ready for the landy show! happy days :)
 
heres my newly fitted halo headlights can now see where am going in the dark not bad for 40 quid
 

Attachments

  • 005.jpg
    005.jpg
    212.6 KB · Views: 200
  • 004.jpg
    004.jpg
    147.7 KB · Views: 181
today I've fitted new rear discs,pads and re greased rear wheel bearings. cleaned up my callipers and fitted a new rocker cover gasket. not bad in 2 hours if I do say so myself.
 
Tightened the drive belt for the power steering to stop it squeaking, greased all my UJ's and checked her oil, water, brake fluid and PS fluid, then gave her a short run out!

Tomorrow we take our RIB and Training Yacht from Blyth to Royal Quays Marina on the River Tyne, ready to host the Blue Peter film crew on Saturday for the Foghorn Requiem, which will be performed off Souter Point, South Shields at 12:30
 
Packed it full of stuff in preparation for driving down to Bristol tomorrow and found the thing that holds the bottle jack in pace in the engine bay, not very exciting but I always wondered how it was supposed to sit in there without causing damage.
 
finallysnapped said:
Packed it full of stuff in preparation for driving down to Bristol tomorrow and found the thing that holds the bottle jack in pace in the engine bay, not very exciting but I always wondered how it was supposed to sit in there without causing damage.
Click to expand...



hope ya end up going to bristol or you wont see us lot :D:D
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
848
BEASTIE 90
B
MinionKing
Freelander 2 (LR2) Freelander 2 Torque pull
Replies
11
Views
666
coltron1
C
stumpyj
TD5 Fuel line to fuel pump clip
Replies
10
Views
1K
Alan Henry Crossley
A
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
954
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
1K
Knappster
Knappster