Dreamcather
Member
Fitted new tailgate door seal, hope the boot stays dry from now on.
ZDomZ
New Member
Well yesterday, I took my 15 inch heep wheels off in preparation for tyre removal rim reoainting and bigger tyres,
So I fitted my 16 inch freelander rims and decided I actually like the look a little more!
I also took off my side bars after whacking the drivers side offroad and realising it was more rust than metal....... So a re weld job is in order!
While I was at it I took off my bonnet deflector for a complete change of look!
So I fitted my 16 inch freelander rims and decided I actually like the look a little more!
I also took off my side bars after whacking the drivers side offroad and realising it was more rust than metal....... So a re weld job is in order!
While I was at it I took off my bonnet deflector for a complete change of look!
Freelaner
Landy Driver
New tensioner bolt?
Alibro
Well-Known Member
Well cuz I know the rulez - no pictures it didn't happen. Here is proof..
Looking good. Sorry but I don't like the deflector
The Docmeister
Active Member
I think I do - certainly in a more chunky off-road type of way. Where do you get them?
DastardlyDan
Active Member
Well cuz I know the rulez - no pictures it didn't happen. Here is proof..
I *need* those foglamp surround thingies... what are they called so I can grab some for my hippo in a few months?
Also - finally picked up the HX55, for the supercharger:
Standard L series turbo for size comparison
Shame it got obliterated in transit.. but the wheels aren't too much thankfully
Dangermike
Active Member
I *need* those foglamp surround thingies... what are they called so I can grab some for my hippo in a few months?
Also - finally picked up the HX55, for the supercharger:
Standard L series turbo for size comparison
Shame it got obliterated in transit.. but the wheels aren't too much thankfully
Please say you will be fitting that supercharge to your l series.... I have to see that!
Dangermike
Active Member
£280 now I think
I'm sure that's what I paid
I'm sure that's what I paid
put your reg in the dvla thing, that'll tell you.
And on the subject of this thread..... fitted a new back box, the old one snapped off. Removed the prop shaft (are blanking plates essential ?) And diagnosed the cause of my crap handbrake - the adjuster is seized solid. Big hammer and small chisel solid. Anyone know where I can buy one ? Been advised to by the whole kit for both sides but I'm too tight for that.
And on the subject of this thread..... fitted a new back box, the old one snapped off. Removed the prop shaft (are blanking plates essential ?) And diagnosed the cause of my crap handbrake - the adjuster is seized solid. Big hammer and small chisel solid. Anyone know where I can buy one ? Been advised to by the whole kit for both sides but I'm too tight for that.
Last edited:
Alibro
Well-Known Member
Started into replacing the belts on my K series. Stopped short at unbolting the engine mounts so it won't be strained all night. Typical though I spotted the brake discs are a tad on the thin side so will need to order replacements.
Another wee job to add to the list. :frown:
Another wee job to add to the list. :frown:
DastardlyDan
Active Member
Obviously!
Originally was thinking about putting it on my R45, but there's not enough space, oddly enough, lol
Had a very quick peek under a hippo bonnet (k series, however) and there's PLENTY of space
GrumpyGel
Well-Known Member
Shame!
