SES88
Well-Known Member
There's no filter with the BMW part, thats the whole point of it, just a plastic piece and a couple of seals with an O ring
There's no filter with the BMW part, thats the whole point of it, just a plastic piece and a couple of seals with an O ring
Epicuser
Ex Freelander Owner
This was my concern too as im not the main driver of this vehicle, but took it for a thrash and these were my exoeriences
2. Handlings not much different, in fact feels better around corners.
3. No scrabbling of wheels but it is an auto box, so wheel spins are out of the question, and I have 3 amigos at present so cant comment on the tc, will have to test it in the wet.
Ah, okay. I was driving a 1.8 manual in 2wd mode in cold and wet weather, which probably explains it, as it has much more power than the L series and the damp & wet conditions made it more frisky.
By comparison, my TD4 was planted, secure and no wheelspin. I've only had wheel spin in it on snow/mud, unlike the 2wd 1.8 manual where I was getting wheel spin all the time.
Nodge68
Well-Known Member
This was my concern too as im not the main driver of this vehicle, but took it for a thrash and these were my exoeriences
3. No scrabbling of wheels but it is an auto box, so wheel spins are out of the question
Wheel spin is a real problem for the V6!! Extreme care is required at junctions
No worries mate and I agree they look loads better with rails... Where's the photo lol
Believe it or not we didn't get home until after 7pm as went visiting. I'm going to give it a clean and polish if weather is good tomorrow.
duncanpage4
Active Member
Drove from Seaford to Failsworth in just under 4 hours early this morning.
Car did approx 29mpg at a steady 90mph.
I should have gone slower but I was eager to get there!!
Will try to stick to a steady 70mph in the way home!!
Car did approx 29mpg at a steady 90mph.
I should have gone slower but I was eager to get there!!
Will try to stick to a steady 70mph in the way home!!
Dangermike
Active Member
Drove it around looking for a scrap yard with a freelander in ..... No luck, tried to see if I took apart the door actuator if I could see why is isn't unlocking with the remote..... When I out it all back in the knob doesn't go down any more!!
And still doesn't unlock
And still doesn't unlock
Ian jones
Well-Known Member
I know diff oil smells, but what came out smelt like a rotten eggy fart with a hint of bins.
I get 42+ at 60
Ian jones
Well-Known Member
SES88
Well-Known Member
JC600
Well-Known Member
Nice , fancy one me sel
Has took a long time to find one in good condition, black and not stupidly priced.
DaddyCoolJordan
New Member
oops not good makes for good reading though
