pardec
Active Member
Hi all....updated pics of my new spots with the protective covers with the SPI Tint fitted.......
Liking the look of the tint on the lights, think i'll try that on mine.
Have you got a link where you purchased it?
Irishrover
Well-Known Member
Changed engine oil + filter, drained and refilled manual gearbox (Getrag)..remember that the filler and drain plugs need an 8mm allen key and mine were very tight. I used an oil syringe to refill and access wasn't too bad, using the oil bottles with a spout would be a waste of time because the tube is not long enough. Replaced both anti roll bar links. Finished off by replacing the diff mounts (All three)
NeilTD4
Active Member
Not today, but Sunday changed the oil and filter, air filter, oil separator filter and the MAF which was a bit of a fiddle especially when I dropped one of the screws which got stuck between the exhaust manifold and the heat shield above
Managed to retrieve it eventually
Just the turbo vent filter to do
Managed to retrieve it eventually
Just the turbo vent filter to do
Not today, but Sunday changed the oil and filter, air filter, oil separator filter and the MAF which was a bit of a fiddle especially when I dropped one of the screws which got stuck between the exhaust manifold and the heat shield above
Managed to retrieve it eventually
Just the turbo vent filter to do
I have a small telescopic magnet picker upperer tool - it's got me out of a few dropping situations
Freelaner
Landy Driver
I have a small telescopic magnet picker upperer tool - it's got me out of a few dropping situations
i've got one of them too (with a led light on it)
to locate dropped items i take a pic between the engine and tray with my mobile
i've got one of them too (with a led light on it)
to locate dropped items i take a pic between the engine and tray with my mobile
That's technology for ya and using yer noddle too
Tempus Fugit
Well-Known Member
Tested and found that I have a balance VIS which is shot. Sending it off for a refurb for around £50, then back to normal.
. Sending it off for a refurb for around £50, then back to normal.
freelandie71
Active Member
Fit a elasticated net pocket to the back door, in the recess next to the main pocket. And serviced the hand brake. It works better now
Fitted £25 abs sensor from fleabay- works a treat, I'm sure the £300 one that the stealer wanted to sell me would have made the amigo's disappear as well !
Was it easy to take the old one out and fit the new one??
freelandie71
Active Member
Coooooooooool after owning the landy for about 5 years and the sun being out I took the landy to a garage and got the a/c serviced and it works 😎. Just have to see now if it leaks or not. But main thing is it works 😊
They should have checked for leaks, but all air con systems can loose up to 3% a year.
freelandie71
Active Member
They did check but I am not that optimistic
just checked it again this morning and so far so good and the sun is out so I am of to town and give it an other blast 
