img_1_1752932333961.jpg
🤣
 
Have you checked the roll bar bushes as well?
A simple test to look for other issues is to brake sharply at a low speed and wait for a "thunk" from the front end.
This usually points towards the lower suspension arm bushes over compressing and allowing the alu arm to come to an abrupt stop without the bush cushioning it.
Blah blah blah... 😝
The bush where the roll bar fastens to the sub frame seems tight and when I waggled the bar by hand (with the drop link disconnected on one side) i couldn't make the noise.
The tie rod and control arm have both been replaced so the bushes should be good
When Eric sat in the passenger side he reckoned it wasn't coming from the wheel area
 
Last edited:
The bush where the roll bar fastens to the sub frame seems tight and when I waggled the bar by hand (with the drop link disconnected on one side) i couldn't make the noise.
The tie rod and control arm have both been replaced so the bushes should be good
When Eric sat in the passenger side he reckoned it wasn't coming from the wheel area
Bit of progress narrowing it down.. small lumps and bumps.. no noise.. larger uneven areas and you hear it rattle.. went over a rubber door bump with just the left wheel and that rattled.
Harsh breaking didn't seem to rattle
 
The bush where the roll bar fastens to the sub frame seems tight and when I waggled the bar by hand (with the drop link disconnected on one side) i couldn't make the noise.
The tie rod and control arm have both been replaced so the bushes should be good
When Eric sat in the passenger side he reckoned it wasn't coming from the wheel area

Flat Eric?

 
Last edited:
Old gal been stud for over a week whilst away on holiday. Dropped a little bit but thats just self levelling as is normal where parked. Fired up first go and straight up to normal height so tret her to a run to Sheffield to my mothers so as to shake the cob webs away :D
 
Bit of progress narrowing it down.. small lumps and bumps.. no noise.. larger uneven areas and you hear it rattle.. went over a rubber door bump with just the left wheel and that rattled.
Harsh breaking didn't seem to rattle
Some places have a shaker type thing that sits on a normal 4 post lift. Watched one being used once to try and find a knock. Car is shook and the fitter feels about until his touch finds the noise.
 
Bit of progress narrowing it down.. small lumps and bumps.. no noise.. larger uneven areas and you hear it rattle.. went over a rubber door bump with just the left wheel and that rattled.
Harsh breaking didn't seem to rattle
Check the condition of the disk backing plate. The little bolt holes rust through🤔
 
I used my 38' to stomp up to a village to give a cheeky girl my number who then gave me hers without hesitation 🤩
That was scary🤣
Then it'll go shopping with me on the Saturday ritual 😵
Used it to come home from that girls house this morning at 6.30😝😊
She's amazing 🤩
 

Similar threads