Grrrrrr said:
Are you talking about the conductive paint?
Click to expand...
That is conductive paint, not a lot of good if there is a crack in the PCB as the flexing will quickly crack the paint.
I solder a thin copper wire to the track either side of the break.
 
Datatek said:
That is conductive paint, not a lot of good if there is a crack in the PCB as the flexing will quickly crack the paint.
I solder a thin copper wire to the track either side of the break.
Click to expand...

That will be the plan, small bit of wire across the crack and hopefully Dopey will have a spare switch pack:)
 
Well its not the switch pack, put the new one in and all of it works apart from the O/S/F window again, so its something else
 
It ****es me off sometimes, you look for a reasonable priced part order it, wait..... get it clean it swap things over, nagging from the wife "when your going to do this, its been on the kitchen table for a week" then the agro of taking the old bit out, putting the new part in...... and where's the butler?? he's having 2 weeks off again!!
 
Started the P38 today as it will be getting used next week.

Sat for a month. started first time. Suspension came up straight away. sounds good, tight revving nicely, ready for a run.
 
Well I got this other part now, I will check it then (I can always re sell that part with the switch pack) thanks m8
 
Dopey said:
It ****es me off sometimes, you look for a reasonable priced part order it, wait..... get it clean it swap things over, nagging from the wife "when your going to do this, its been on the kitchen table for a week" then the agro of taking the old bit out, putting the new part in...... and where's the butler?? he's having 2 weeks off again!!
Click to expand...
You shoudn't park the motor on the kitchen table.:rolleyes::D:D Some women have no sence of humour.
 
I don't suppose anyone is around the Wiltshire area and has some kit we can borrow? We need to jack up both the P38s and find some axel stands that will hold them and nowhere around here has any! Will pay in beer tokens, fuel and Bix will probably kiss you.
 
23108924 said:
I don't suppose anyone is around the Wiltshire area and has some kit we can borrow? We need to jack up both the P38s and find some axel stands that will hold them and nowhere around here has any! Will pay in beer tokens, fuel and Bix will probably kiss you.
Click to expand...

P38 is about 2/1/2 tons with a full tank. Axle stand on each corner only takes a quarter of that. 2 ton stands more than enough. Halfords do some nice 3 ton ones.
 
You must log in or register to reply here.

Similar threads

A
Range Rover L322 - not turning over
Replies
12
Views
2K
gold rover
gold rover
B
L320 range rover sport 3.0 tdv6 loosing power steering fluid
Replies
3
Views
533
Mark Piercy
Mark Piercy
F
1980 Range Rover 2 door v8 to 300tdi
2
Replies
20
Views
1K
Grrrrrr
Grrrrrr
T
Non start
Replies
3
Views
717
Datatek
Datatek
T
Fan Clutch??
Replies
14
Views
799
Grrrrrr
Grrrrrr