Hairy
New Member
Rite, didn't do that, Gona take it off again to check the NS at the weekend so will do that then, A Million Thanks and may the RR Gods smile on you.
Rite, didn't do that, Gona take it off again to check the NS at the weekend so will do that then, A Million Thanks and may the RR Gods smile on you.
tomcat59alan
Well-Known Member
Fitted the new to me steering wheel after changing the bottom plastic boss which was damaged in transit. When tested the volume buttons didn't work !! Stripped the ones out of my old wheel and changed them. All back together and the seller has made a partial refund for the problems I had. Result, and thank you GMH vehicle recyclers Cardiff, pleasure doing business with you.
Littelwill
Well-Known Member
Cleaned my MAF sensor and fitted new rear seatbelt plugs as old ones had started to stick and give up.
Druim
Well-Known Member
open end spanner, oil filter tool, large gripping tool or eat your oats in the morning
Lyndasbottom
Active Member
Eventually got my rear bumper off, had to attack it with an angle grinder. Surprised to see that the mounting arrangements are replaceable so ordered two new rear mounting brackets and one side mounting bracket. Chassis itself is completely rust free so bit of a result as I thought I'd have to get the Mig welder out to rebuild the mounts. Changed over the colour coded inserts to the new bumper. I'll give it all a good coat of Waxoyl tomorrow ready for re-installation when the new bits arrive next week. Unfortunately I'll have to use my other car for a few days (Porsche 944 Turbo SE - 250 BHP of pure fun!!!) as the wife will want to use the family car (VW Golf).
biketeacherdave
Well-Known Member
yes they should but if you look at your new one you will see you can get a spanner on it to
mickwall
Active Member
Yes I see that but can't seem to fit a spanner to the old one! I'll try a strap wrench tomorrow.
JohnnyCrash
New Member
Passed its MOT with no fails or advisories
biketeacherdave
Well-Known Member
replaced the rocker cover gaskets to cure an annoying oil leak hopefully all cured. new inlet gasket for good measure.
what a pig of a job but having done it once reckon i could do it again in a couple of hours
what a pig of a job but having done it once reckon i could do it again in a couple
of hours
ukadamwest
Well-Known Member
removed the headlining last week from the classic.. today glassed some cracks and weak spots on the biscuit board, before the new foam goes on, removed the sunroof panel, un froze the drive cables, looks like the clutch is slipping does anyone know which way to turn the 21mm hex head to increass clutch torque ?? Ie is it standard or reverse thread ? going either way makes no difference !
Removed the sunroof headlining panel..
and on the P38, took the wife to a get a floor standing lamp
Removed the sunroof headlining panel..
and on the P38, took the wife to a get a floor standing lamp
