@Henry_b where you get them clips from?

We need someone with a 3D printer to make the lower ones, you can't get them any more, and it's not like they are hard to make
I should really get my 3d printer out and running again - so many things I find that I need to replace but could print them.
 
I should really get my 3d printer out and running again - so many things I find that I need to replace but could print them.
I would love say 10-15 of the bottom clips..

BTR4428-PLINTH-CLIP.jpg
 
Things like that don't tend to print well and are not very strong. Mind you they do make a carbon fibre filament :D
 
Things like that don't tend to print well and are not very strong. Mind you they do make a carbon fibre filament :D

I dont know anything about 3D printing, it seems like very hard plastic and not very pliable, like you say if there was some carbon in it, that would make it tougher?
 
I dont know anything about 3D printing, it seems like very hard plastic and not very pliable, like you say if there was some carbon in it, that would make it tougher?

I have printed lots of things over the last few years and find anything less than 4mm thick has very little strength.
I should really try a few different materials, Nylon, ABS, Carbon fiber. It also makes a big difference how it's printed.
 
If you test continuity fron 85 to earth then that should prove the circuit from relay 4 through the screen is intact. Then put a thin wire in 85and put the relay back,attach a test lamp and start the engine,switch on the screen and if the test lamp lights then you have power going to the screen and that relay 5 is doing its job.;)
I know relay 5 is doing it's job because the passenger side works a treat ;)
 
I know relay 5 is doing it's job because the passenger side works a treat ;)
Yup,but it also activates relay 4 for the drivers side.good to know 5 works,that means your switch is earthing relay15 which is ignition powered to activate relay 5.I suppose they could have made it more complicated if they tried.;):D
 
Felt a bit of flex when I let the clutch up and suspect engine mount rubbers are getting tired. £15 for Bearmach - been there before and refitted originals they were so ****e so Land Rover it has to be. £70+VAT so that's a job for warmer weather.

Dusting of snow but not enough to tempt my away from my beer.
 
Last edited:
I used to live in Earls court, then ausi birds I am sure had a tick off list of all the different nationalities hey had, and ticked us off the list, not that I cared much, never had a bad one between the sheets.
Darn right there:D:D
 

Similar threads